Viewing The Rmon History Table - Cisco SF500-24 Administration Manual

Viewing Statistics
Managing RMON
STEP 2
STEP 3
STEP 4
STEP 5
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 500 Series Stackable Managed Switch Administration Guide
page, below. The only field is that is on this page and not defined in the Add page
is:
• Current Number of Samples—RMON is allowed by standard to not grant all
requested samples, but rather to limit the number of samples per request.
Therefore, this field represents the sample number actually granted to the
request that is equal or less than the requested value.
Click Add. The Add RMON History page is displayed.
Enter the parameters.
• New History Entry—Displays the number of the new History table entry.
• Source Interface—Select the type of interface from where the history
samples are to be taken.
• Max No. of Samples to Keep—Enter the number of samples to store.
• Sampling Interval—Enter the time in seconds that samples were collected
from the ports. The field range is 1-3600.
• Owner—Enter the RMON station or user that requested the RMON
information.
Click Apply. The entry is added to the
Configuration file is updated.
Click History Table to view the actual statistics.

Viewing the RMON History Table

History Table
The page displays interface-specific statistical network samplings.
The samples were configured in the History Control table described above.
To view RMON history statistics:
Click Status and Statistics > RMON > History. The History page is displayed.
Click History Table. The History Control Table page is displayed.
Click History Table to go to the History Table page.
From the History Entry No. list, select the entry number to display the samples
associated with that history entry.
History Control Table
2
page , and the Running
21