Key Management - Cisco SF500-24 Administration Manual

RIP
Configuring RIP Through the WEB GUI
STEP 1
STEP 2
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
Populate an Access List
To populate an access list with IP addresses.
Click IP Configuration > Access List > Source IPv4 Address List. The Source
IPv4 Address List page is displayed.
To modify the parameters of an access list, click Add to open the Edit Access List
page and modify any of the following fields:
• Access List Name—Name of the access list.
• Source IPv4 Address—Source IPv4 address. The following options are
available:
- Any—All IP addresses are included.
- User Defined—Enter an IP address.
• Source IPv4 Mask—Source IPv4 address mask type and value. The
following options are available:
- Network Mask—Enter the network mask (for example "255.255.0.0").
- Prefix Length—Enter the prefix length.
• Action—Action for the access list. The following options are available:
- Permit—Permit entry of packets from the IP address(es) in the access
list.
- Deny—Reject entry of packets from the IP address(es) in the access list.

Key Management

This section describes how to configure key chains for applications and protocols,
such as RIP. See RIP Authentication
for authentication.
To create a key chain, do the following:
Create a key chain with a single key in it, using the Key Chain Settings page.
Add additional keys, using the Key Settings page.
for a description of how RIP uses key chain
23
435