Defining Snmp Communities - Cisco SF500-24 Administration Manual

Configuring SNMP

Defining SNMP Communities

STEP 4
Defining SNMP Communities
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
• Authentication Key—If the authentication method is either an MD5 or SHA
key, enter the MD5 or SHA authentication key.
• Privacy Key—16 bytes are required (DES encryption key). This field should
be exactly 32 hexadecimal characters.
If your security level is authNoPriv, you still need to enter a Privacy Key
NOTE
value of 32 hexadecimal digits. However, the key will not be used.
Click Apply to save the settings.
Access rights in SNMPv1 and SNMPv2 are managed by defining communities in
Communities
the page. The community name is a type of shared password
between the SNMP management station and the device. It is used to authenticate
the SNMP management station.
Communities are only defined in SNMPv1 and v2 because SNMPv3 works with
users instead of communities. The users belong to groups that have access rights
assigned to them.
Communities
The page associates communities with access rights, either directly
(Basic mode) or through groups (Advanced mode):
• Basic mode—The access rights of a community can configure with Read
Only, Read Write, or SNMP Admin. In addition, you can restrict the access to
the community to only certain MIB objects by selecting a view (defined in the
SNMP Views
page).
• Advanced Mode—The access rights of a community are defined by a group
(defined in the
security model. The access rights of a group are Read, Write, and Notify.
To define SNMP communities:
Click SNMP > Communities. The
This page displays a table of configured SNMP communities and their properties.
Click Add. The Add SNMP Community
Groups
page). You can configure the group with a specific
Communities
page is displayed.
page is displayed.
22
416