Downloading Or Backing-Up A Configuration Or Log - Cisco SF500-24 Administration Manual

Managing System Files

Downloading or Backing-up a Configuration or Log

STEP 3
Downloading or Backing-up a Configuration or Log
NOTE
STEP 1
STEP 2
STEP 3
Cisco 500 Series Stackable Managed Switch Administration Guide
Click Apply. The active image selection is updated.
Download/Backup Configuration/Log
The
configuration file types or the flash log on the switch to a file on another device, or
the restoration of configuration file of various types from another device to the
switch.
If the device is working in stack mode, the configuration files are taken from the
master unit.
When restoring a configuration file to the Running Configuration, the imported file
adds any configuration commands that did not exist in the old file and overrides
any parameter values in the existing configuration commands.
When restoring a configuration file to the Startup Configuration or a backup
configuration file, the new file replaces the previous file.
When restoring to Startup Configuration, the switch must be rebooted for the
restored Startup Configuration to be used as the Running Configuration. You can
reboot the switch by using the process described in the
section.
To backup or restore the system configuration file:
Click Administration > File Management > Download/Backup Configuration/
Log. The Download/Backup Configuration/Log page opens.
Select the Transfer Method.
If you selected via TFTP, enter the parameters. Otherwise, skip to
Select either Download or Backup as the Save Action.
Download Save Action—Specifies that the file on another device will replace a
file type on the switch. Enter the following fields:
a. Server Definition—Select whether to specify the TFTP server by IP address
or by domain name.
b. IP Version—Select whether an IPv4 or an IPv6 address is used.
page enables the backup from
Rebooting the Switch
4
STEP 4.
40