Operational Instructions - Stamina 1750 Power Tower System Owner's Manual

OPERATIONAL INSTRUCTIONS

3. Refer to illustration B. lift the Bench from the stabilizer of the REAR SUPPORT(40). When the BENCH
EXTEND ARMS(42) near the vertical position, as shown in illustration C, push down the stabilizer
slightly and continue to fold the Bench to other side. The Bench should look as shown in illustration D
after folded.
B.
SWITCH THE BENCH
The Bench is preset under the PULL-UP BAR(12).
You will need to fold and switch the Bench to other
side when you want to do the pull-up workout.
Follow the process below to switch the Bench:
1. Adjust the BENCH CUSHION(47) to the lowest
decline angle and secure with the BALL PIN(48).
2. Unlock the REAR SUPPORT(40) from the
BENCH EXTEND ARMS(42) by pulling out the
LONG BALL PIN(49). Store the LONG BALL
PIN(49) by sliding it back into the BENCH
EXTEND ARMS(42). The LONG BALL PIN(49)
must not pass through the REAR SUPPORT(40)
as shown in illustration A.
C.
Slightly push
down here.
14
Meijer.com
A.
D.