Operational Instructions - Stamina DT Plus Power Owner's Manual

OPERATIONAL INSTRUCTIONS

PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can attach the PEDAL STRAP(44) to the lower
position in the PEDAL CAP(43) as shown in illustration 1 below. Run the PEDAL STRAP(44) through the
opening from the bottom of the PEDAL CAP(43). Pull the PEDAL STRAP(44) to make the Knot against the
bottom of the PEDAL CAP(43). Run the PEDAL STRAP(44) through the opening in the PEDAL CAP(43)
on the other side from the top as shown in illustration 1, then pull the end of the PEDAL STRAP(44) up to
attach onto the upper part of the PEDAL STRAP(44) with the Hook & Loop Pad.
Attach the end of the PEDAL STRAP(44) to different position with the Hook & Loop Pad to adjust the length.
Refer to illustration 2.
1.
Hook & Loop Pad
LEVELING THE Stamina® DT Plus Rower
Place the Stamina® DT Plus Rower in the area where it will be used. It is recommended that the
Stamina® DT Plus Rower be placed on an equipment mat. Adjust the STANDS(52) under the FRONT
STABILIZER(3) and the REAR STAND(2) so that the Stamina® DT Plus Rower sits on the floor without
rocking. Refer to the instructions below the illustration.
52
52
Knot
2
End of Pedal Strap
52
Loosen the NUTS(M10x1.5) until they touch the STANDS
(52). Adjust the STANDS(52) for leveling. Tighten the NUTS
(M10x1.5) securely against the FRONT STABILIZER(3) and
the REAR STAND(2) to lock the STANDS(52) in position.
12
3
3
52
2.
Hook & Loop Pad
NUT(M10x1.5)