Memory Module - HP ENVY 14 SPECTRE Maintenance And Service Manual

6. Disconnect the power connector cable (2) from the system board.
7. Remove the system board (3) by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.

Memory module

Description
4-GB memory module (PC3, 12800, 1333-MHz)
Before removing the memory module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Solid-state drive connector board cable (see
b. Card Reader board cable (see
c. Top cover (see
d. WLAN module (see
e. Wireless audio module (see
f. System board (see
Battery on page 31), and then remove the following components:
Card Reader board cable on page
Top cover on page 38)
WLAN module on page
Wireless audio module on page
System board on page
Solid-state drive on page
51)
49)
55)
Component replacement procedures
Spare part number
641369-005
33)
35)
57