Exit Programming Mode; Zone Programming; Select Zone; Zone Selected - Honeywell NOTIFIER IFS-2600 Technical Installation Manual

IFS-2600 Installation & Programming Manual

EXIT PROGRAMMING MODE

Use the "NEXT" & "PREVIOUS" keys to scroll through "YES" & "NO". Once the desired option has been
highlighted, pressing the "SELECT" button will select it.
Highlighting "YES" and pressing "SELECT" will write all changes made to the system memory (E
the panel will then restart.
WARNING!! The above action cause the panel to drop any door holders / air-conditioning if connected.
Highlighting "NO" and pressing "SELECT" will ignore any changes made to the programming and exit back to
normal panel operation without restarting.
Note: This does not apply to saving changes to the time. Changes to time are saved immediately the
select key is pressed when in the time adjustment menu.

ZONE PROGRAMMING

SELECT ZONE #

Use the "NEXT" & "PREVIOUS" keys to scroll through "ALL" "1" "2" "3"
Up to the maximum number of zones fitted and then wrap around. Once the desired zone number has been
highlighted, pressing the "SELECT" button will select it. Pressing "EXIT" at this stage will return to main menu.

ZONE SELECTED

Use the "NEXT" & "PREVIOUS" keys to scroll through "TYPE" & "OUTPUT". Once the desired option has
been highlighted, pressing the "SELECT" button will select it.
"SELECT ZONE #".

ZONE TYPE

Use the "NEXT" & "PREVIOUS" keys to scroll through
P/N 10069 ECN08-0066
SAVE CHANGES
YES (NO)
SELECT ZONE #
(ALL)
ZONE # ALL
(TYPE) OUTPUT
ZONE # ALL TYPE
STD LATCHING
STD LATCHING
STD LATCHING AVF
NON LATCH
NON LATCH 20S
TIME DELAY 10S
TIME DELAY 20S
TIME DELAY 30S
TIME DELAY 40S
TIME DELAY 50S
TIME DELAY 60S
Pressing "EXIT" at this stage will return
Page 31
2
ROM) and