Figure 3-66 Motion Detection Actions 2 Screen - Honeywell HRXD9 User Manual

Configuration
14. Highlight the box under the Notify heading and press
15. In the Actions 2 tab, highlight the desired box under the PTZ heading, and press
16. Highlight the desired box under the Spot Monitor heading, and press
17. You can save your Motion Detection changes by highlighting Save and pressing
82
Note For the Alarm-Out action, the alarm output and beep you select
should be set to the Event mode in the Alarm-Out setup screen,
Schedule tab (see
entire list On and Off by highlighting Notification and pressing
toggle the individual items On and Off by highlighting that item and pressing
Highlight OK and press
Note For the Notify action, the notify item you select should be
enabled in the Notification setup screen and the DVR should be
registered in the RAS (Remote Administration System).
Figure 3-66
. A list of PTZ presets appears. Select the preset position for each PTZ camera,
where you want PTZ cameras to move to whenever the DVR detects motion on
the selected camera's input.
SPOT monitors and cameras appears. Each SPOT monitor can be associated
with a camera. The DVR will display the associated camera on the SPOT monitor
whenever it detects motion on the selected camera.
. Selecting Cancel exits the screen without saving the changes.
Alarm-Out
to accept your changes.
Motion Detection Actions 2 Screen
Screen, page 65).
. You can toggle the
. You can
.
. A list of