Notify Alert - AT&T SynJ SB67108 User Manual

Getting started
Mailbox setup
When the handset is idle, press MENU
1.
2. Press DIR or CID
3. Press �ENTER twice to select
MENU
Set access code.
4. Use the dial pad to enter a four-digit number. Press
�CLEAR to backspace and delete a digit.
OFF
5. Press the Next softkey or
the password and to select Mailbox security.
6. Press DIR or CID
7. Press �ENTER to save the setting and return
MENU
to the previous menu. There is a confirmation
tone. To exit without making changes, press
�CLEAR.
OFF
NOTES:
1. The access code must have four digits.
2. You will hear an error tone and the screen displays Please enter another if you enter
an access code that is already assigned.

Notify alert

Use this feature to receive notification calls to any phone number you
set (such as a cellular phone or paging device) after a new message
has been recorded to the handset mailbox. To receive notification
calls, you must save the number you wish to be notified at to the
handset, and then set the system to call this number after it finishes
recording a message.
If the number called has caller ID service, there will be an indication
of the notification call. When you receive a notification call, you
hear about 15 seconds of silence; then the call is ended. There is
no message sent and the call is only made once. If the call is not
picked up within three rings, the handset cancels the call. You may
not receive the call if the number you set is busy, not available or off
during the call.
to scroll to Mailbox setup.
�ENTER to save
MENU
to select On or Off.
20
.
�ENTER
Set access code Set access code
Notify alert
Enter mailbox
access code
:0001
Mailbox security
:Off
Back
Back Next
Back