Notify Alert - AT&T SB67108 User Manual

Getting started
Mailbox setup
1. When the handset is idle, press MENU
2. Press DIR or CID
3. Press /ENTER twice to select
MENU
Set access code.
4. Use the dial pad to enter a four-digit number.
Press
OFF
digit.
5. Press the Next softkey or
the password and to select Mailbox security.
6. Press DIR or CID
7. Press /ENTER to save the setting and return
MENU
to the previous menu. There is a confirmation tone. To exit without
making changes, press
NOTES:
1. The access code must have four digits.
2. You will hear an error tone and the screen displays Please enter another if you enter
an access code that is already assigned.

Notify alert

You can receive notification calls to your cell phone or paging device
after each new phone call message has been recorded to the handset
mailbox. You can remotely access the message from a touch-tone
telephone (see page 65). To receive notification calls, you must save
your telephone number on the handset, and then set the system
to call that number after it finishes recording a message. It is best
to enter a telephone number that has caller ID service. When you
receive a notification call you will only hear silence. The silence will
last for about 15 seconds and then the call ends. If no one picks
up the call within three rings, the telephone base stops calling it.
The system only calls the alert number once. If your paging device
is busy, not available or off during the call, you will not receive the
notification call.
to scroll to Mailbox setup.
/CLEAR to backspace and delete a
MENU
to select On or Off.
OFF
/ENTER
/ENTER to save
/CLEAR.
21
.
Set access code Set access code
Notify alert
Back
Enter mailbox
access code
:0001
Back
Mailbox security
:Off
Back
not receive the
Next