Connecting The Power Between Joined Panels - Chauvet MVP Ta8 Curve User Manual

Connecting (Cabling) Each MVP™
Connecting the
Power Between
Joined Panels
MVP™ Ta8 Curve User Manual, Rev. 1
Power cable panel connections can also use different configurations. The basic
configuration to connect the main power supply from one panel to the next is:
• The main power is connected to the first panel's Power Input or Output.
• A powerCON® cable is then connected to the first panel's Power Output and
connected to the next panel's Power Input.
• The connections continue until all panels are connected.
The power input cord for the main is included when purchasing an 6-pack flight
case ONLY. CHAUVET® recommends the Neutrik® powerCON® extension cable,
item number PCLEAD50FT, available from CHAUVET®, if additional cables are
required.
Connect power between the panels using the same procedure as the signal only using
the Power Input and Power Output connectors. You must adhere to the power-linking
specifications for each MVP™ model.
Refer to the Power Linking
linked based on voltage from a single power connection.
Power linking more panels than recommended will void your warranty and
increase the risk electrocution or fire!
Refer to the following diagram for an example of power connection from the main and
to each connected panel.
This example is using an MVP™ Ta8 Curve power linking 7 panels horizontally
@ 120 V.
section for details on the number of panels that can be
MAIN POWER IN
MAIN POWER IN
MAIN POWER IN
15