Table of Contents
Advertisement
Connecting (Cabling) Each MVP™
Connecting Power
and Signal Cables
Connecting
the Signal Between
Joined Panels
May be used to run
a backup line to the
VIP™ Driver
DVI-D
VIP™ Driver
Video Signal Cable
in from VIP™ Driver
max. cable length
MVP™ Ta8 Curve User Manual, Rev. 1
The following sections provide information and diagrams on connecting signal and power
between panels.
Refer to the
Introduction
and item numbers.
Signal cable panel connections can use several different configurations. The basic
configuration to connect the signal from one panel to the next is as follows.
• The source signal is connected to the first panel.
• A signal cable is then connected from the first panel.
• The connections continue to daisy-chain until all panels are connected.
• The route of the cables used to make the signal connections can vary.
The following diagrams are recommended suggestions for signal connections between
24 or less panels, and more than 24 panels.
Refer to
Connecting Signal Input
signal from the source.
This diagram shows an example of a simple signal connection using 24 or less MVPs.
100 m/328 ft
or
Operation
sections in this User Manual for available cables
for information and instructions on connecting the
Signal Jumper Cable
13
Advertisement
Table of Contents
