Table of Contents
Advertisement
9. Technical Information
MVP™ Ta8 Curve
Maintenance
Troubleshooting Guide
Symptom
All LEDs are blinking
LEDs on a specific circuit are not
lit/working
All LEDs do not light
MVP™ Ta8 Curve does not power up
(LED power indicator does not light
during "self-test")
MVP™ Ta8 Curve displays no
images or spotted images
20-
To maintain optimum performance and minimize wear, the user should clean this
product regularly. Usage and environment are contributing factors in determining the
cleaning frequency.
As a rule, clean this product at least twice a month. Dust build-up reduces light output
performance and can cause overheating. This can lead to reduced light source life and
increased mechanical wear.
To clean an MVP™ Ta8 Curve, follow the recommendations below:
• Unplug the panel from power.
• Wait until the unit is cold.
• Use a soft brush to remove dust collected on the external components.
• Wipe the outside of the LED strips with a soft, lint-free cloth dampened with a solution
of water and detergent. Apply gentle pressure only.
• Make sure all connections are thoroughly dry before reconnecting power and signal
cables.
Always dry the external surfaces carefully after cleaning them.
Cause(s)
Contact failure
Power output cable may be connected
incorrectly
Power cables may be plugged in
reverse
Output cables connected incorrectly
No power
Loose or damaged power cord
Faulty power connection inside the
MVP™ Ta8 Curve
Faulty external power supply
If you still experience technical problems after trying the above solutions or if you
need to send the unit for repair, contact CHAUVET® Technical Support.
Technical Information
Action(s)
Fix the loose LEDs or try re-plugging
Remove and connect correctly
Find the incorrectly connected cables
and reconnect properly
Check for voltage on outlet
Check power cord
Send for repair
Disconnect and reconnect the signal
cable, or replace the cable
MVP™ Ta8 Curve User Manual, Rev. 1
Advertisement
Table of Contents
