CYBEX Arc Trainer 600A Owner's Service Manual page 96

B. Tape the new 10 pin connector to the old lower
display cable. NOTE: Be sure to tape the correct
ends together. See Figure 33.
C. Gently pull both cables through the unit. NOTE:
Stop pulling before the new cable goes down
into the upright.
D. Remove the tape and discard the old cable.
E. Confirm that the cable is routed through the
access holes (see Figure 30) and through the
wire holder bracket (see Figure 32).
F. Connect the display cable to the lower control
board.
7. Attach the console.
A. Place the console handrails on top of the
gaskets. See Figure 26.
B. Using a hex key, attach the four screws and four lock washers securing the handrail in
place.
8. Secure the cable.
A. Check to see that all of the connectors are connected firmly in their proper place.
B. Place the lower board shield in position and snap it in.
9. Attach the access cover.
A. While being sure not to pinch any cables, place the access cover in position.
B. Using a Phillips head screwdriver, attach the four screws removed in step 2A.
10. Attach the left wheel.
A. Using a 9/16" wrench and a 3/16" hex key, attach the bolt and nut securing the left
transport wheel in position. See Figure 30.
B. Remove the wooden block from under the unit.
11. Test the unit for proper operation.
A. Connect the power cord into the power outlet.
B. Turn the main power switch above the power inlet to the on (I) position.
C. Operate the unit at all levels to verify proper operation.
Page 7-40
Cybex Arc Trainer Owner's & Service Manual
Lower
Display
Cable
Upright
Figure 33
Gasket