CYBEX Arc Trainer 600A Owner's Service Manual page 88

Upper Display Board
Display Cable Ports
Lower Display Board
Figure 25 NOTE: This figure does not show handrails or lower console back.
4. Attach the new display board.
A. Place the display board in position and gently push the display board down into the
CSAFE board connector.
B. Using a Phillips head screwdriver, four screws securing the display board to the
console.
5. Connect the cables.
A. Connect these cables into the display board: the display cable (2 connectors); the two
upper switch membrane connectors; the lower switch membrane connector; the
contact heart rate cable and the upper to lower board jumper. See Figure 25.
6. Check the connections.
A. Check to see that all of the cables are connected firmly in their proper place.
7. Secure the console back.
A. While being sure not to pinch any cables, use a Phillips head screwdriver to tighten
five screws securing the top console back to the console front.
Page 7-32
Cybex Arc Trainer Owner's & Service Manual
Upper Switch Membrane Ports
RJ-45 Port
Contact Heart
CSAFE Board
Rate Port
Connects to
Display Board
Lower Switch
Upper to
Membrane
Lower Board
Jumper
Heart Rate
Board