Led Functions; Key Functions - CYBEX Arc Trainer 600A Owner's Service Manual

Cybex Arc Trainer Owner's & Service Manual

LED Functions

LEDs are used to indicate the status of many of the unit inputs. After entering
Test Mode refer to the following list to check that these LEDs are functioning
properly:
Heart LED — Blinks on blue with every signal from the contact heart rate
receiver and red for wireless signals (Polar).
Weight LED — Blinks on when CSAFE data is being received.
Level LED — Blinks on when CSAFE data is being transmitted.
Lower Left Window — The numbers indicate actual elevation. The decimal
point before the numbers shows the activation of the level 3 position switch in
the elevation motor (on above level 3). If dashes are shown in the display, the
unit is either above or below the level 3 position switch, requiring it to be
manually run through the switch to begin indicating actual elevation.
Lower Right Window — The numbers indicate resistance (0-100). The right
most decimal point indicates the pulses from the speed sensor.

Key Functions

While in Test Mode press the following keys for desired information:
Hill Interval key — Lights all of the LEDs for a short period of time.
Weight Loss key — Lights only the columns.
Strength key — Lights only the rows.
Incline — Run elevation motor up.
Incline — Run elevation motor down.
+
Resistance (plus) — Run resistance up.
-
Resistance (minus)— Run resistance down.
Distance — Press once for odometer information (DST) to appear in the
speed window.
Press again for hourmeter information (HRS) to appear in the speed window.
Press three times for number of starts information (USES) to appear in the
speed window.
Press four times for number of positions the elevation (ELV) has ever moved.
Example: if a user runs the elevation from 2 to 3, 1 position is added to this
number.
Strides Per Minute — Displays and cycles through error log. Up to 10 errors
can be stored.
Scan — Clears error log when pressed twice while in error log mode.
Mets — Displays the torque in ft-lbs, (relative to LOAD).
Calories — Displays brake pulse width (PWM) value (the value of brake load in
A/D counts). The number range is relative to brake current and goes from 0-200.
Enter — Required to save setup values.
Table of Contents . . . . . . . . . iii
7 Service
Warnings/Cautions . . . . . . . 7-1
Test Mode . . . . . . . . . . . . . . 7-2
LED Functions . . . . . . . . . . . 7-3
Key Functions . . . . . . . . . . . 7-3
Error Codes . . . . . . . . . . . . . 7-4
Speed Sensor Adjustment . 7-5
Drive Belts . . . . . . . . . . . . . . 7-7
Eddy Current Brake. . . . . . 7-13
Elevation Motor . . . . . . . . . 7-16
Power Switch . . . . . . . . . . 7-20
Upper Pillow Blocks . . . . . . 7-22
Lower Pillow Blocks . . . . . 7-26
Pedal Arm & Linkage Arm . 7-28
Lower Control Board . . . . . 7-29
Upper Display Board . . . . . 7-31
Contact Heart Rate Board. 7-33
CSAFE Board . . . . . . . . . . 7-35
Upper Display Cable . . . . . 7-36
Lower Display Cable . . . . . 7-38
Display Overlays . . . . . . . . 7-41
Parts List . . . . . . . . . . . . . . 7-43
Exploded Views. . . . . . . . . 7-45
Schematic . . . . . . . . . . . . . 7-51
Page 7-3