CYBEX Arc Trainer 600A Owner's Service Manual page 70

5. Remove the left crank cover.
A. Using a Phillips head screwdriver, remove the
three screws securing the left crank cover in
place. See Figure 6.
B. Remove the left crank cover.
! WARNING: Failure to release the drive belt
6. Release the drive belt tension.
A. Using a 7/16" socket wrench, loosen the two
screws on the lower pivot shaft until the screws are raised 1/2" (1.25 cm) above the
shaft. See Figure 15. NOTE: The drive belt tension is now released.
! WARNING: Do not touch components on the lower board. A charge can remain after
7. Disconnect the brake cables.
A. Pull out on the lower board shield. See Figure 9. NOTE: It will snap out.
B. Locate the two brake cables on the lower board that are labeled J1 and J2.
C. Disconnect the two brake cables from the lower board.
! CAUTION: Pulley on eddy current brake is sharp. Wear work gloves to protect your hands.
8. Remove the eddy current brake.
A. Wear work gloves whenever handling the eddy current brake. The pulley is sharp. See
Figure 16.
Figure 16
Page 7-14
Cybex Arc Trainer Owner's & Service Manual
tension may cause personal injury
and may damage the unit.
unplugging the power cord and turning off the unit.
Screw (4)
Pulley
Pins on
Brake
Mount
Flywheel
Bracket
Secondary
Drive Belt
Figure 15
Orientation of
the Cable
Threaded Hole (4)
Loosen Screws
Lower Pivot
Shaft
Non-Threaded Hole (4)
Screw (4)