Table of Contents
Advertisement
PS Custom Page Edit.eps
3.
In the PostScript Custom
Page Size Definition
window, Choose your
[paper feed direction]
from the drop-down list.
The available choices
are:
Short edge first
Long edge first
Short edge first
flipped
Long edge first
flipped
Notice that the size ranges available swap places when you
change the paper feed direction between a portrait and a
landscape choice.
Remember that the width of the multipurpose tray is
limited to the long edge of an A4 sheet 11.7 inches
(297mm), so, if your paper is longer than this, you will
have to feed it short edge first.
4.
You can also position the page image on the paper to
avoid printing too close to the edge by choosing an
[Offset].
Offset relative to [perpendicular] direction adds to your left
margin.
Offset relative to [parallel] direction adds to your top
margin (normal feed) or bottom margin (flipped feed).
5.
Click [OK] to close the PostScript Custom Page Size
Definition window.
6.
Click [OK] to close the Advanced Options window.
7.
In the driver's window, choose the [Multipurpose Tray] as
the [Paper Source].
The page is portrait (tall) format and you will feed
the top of the page into the MFP.
The page is landscape (wide) format and you will
feed the top of the page into the MFP.
The page is portrait (tall) format and you will feed
the bottom of the page into the MFP.
The page is landscape (wide) format and you will
feed the bottom of the page into the MFP.
A guide to printing > 222
Advertisement
Table of Contents
