Table of Contents
Advertisement
D
OCUMENTS RECEIVED ARE LIGHT OR HAVE VERTICAL STREAKS ON THEM
MFP
AND
IS NOT OUT OF TONER
Gently wipe the lens surface of the MFP's LED array, and then
check to see if the machine is working properly
LED head" on page
remove the image drum
page
121.), tap the toner cartridge, and slowly swing it 20 to 30
degrees vertically several times. Be careful not to let the toner
leak from the cartridge. If this does not work, the image drum
unit may need to be replaced. Contact your supplier to get a
replacement.
MFP
IS SET FOR DELAYED TRANSMISSION BUT IT DID NOT SEND
Check the display to make sure that the MFP is set to the correct
time and date
MFP
WILL NOT POLL A REMOTE MACHINE
Call the person at the remote machine and make sure that they
have loaded documents and that their machine is set to polling
transmission mode.
MFP
IS CONNECTED TO A
Be certain that the dial prefix is entered before the telephone
number for each number dialled or programmed into the MFP
(See "Connecting to a PBX" on page
MFP
ALWAYS ANSWERS BEFORE ITS POSSIBLE TO USE THE EXTERNAL
TELEPHONE
If an external telephone is connected, change the MFP's ring
response setting
F
AXES RECEIVED SOMETIMES LOOK DISTORTED
If the document received is wider or longer than the paper loaded
in the paper tray, the machine automatically reduces the width
or length of the document so that it will fit on the paper. This type
of problem could also be communication related.
136.). If the MFP still does not work properly,
(See "Image drum replacement" on
(See "Initial set up" on page
PBX
BUT IT IS NOT POSSIBLE TO DIAL OUT
(See "Advanced set up" on page
Troubleshooting > 162
(See "Clean the
64.).
68.).
65.).
,
Advertisement
Table of Contents
