This operation changes according to the Auto Cut settings.
Paper Source
Roll Auto Cut On
Roll Auto Cut On
Roll Auto Cut Off
Roll Auto Cut Off
Note:
This setting is available for roll paper only.
INTERFACE
You can select an interface to receive your print data. When you
select AUTO, the printer automatically switches between interfaces,
depending on which one is receiving data first. When you select
USB, IEEE1394, or OPTIONAL I/F CARD, only the selected interface
receives your print data. If no more print job is received, the
printer returns to an idle state after 10 seconds or more.
CODE PAGE
You can select a code page: PC437 (extended graphics) or PC850
(multilingual).
214
The Control Panel
Print Page Line
On
Off
On
Off
Printer's Operation
Prints a page line on the right
side only, and cuts paper
automatically after the print
job.
Does not print any page lines,
and cuts paper automatically
after the print job.
Prints page lines on the right
side and below the data, but
does not cut paper
automatically after the print
job.
Does not print any page lines
and does not cut paper.