3
Paper check light
(red)
4
Ink check light
(red)
Combination of buttons
This section describes the functions available when several
buttons are pressed at the same time.
Buttons
1. Power button
2. Pause button
On:
No paper is loaded in the manual feed when
Sheet
is selected as the paper source.
Roll paper is out when Roll Auto Cut On
Roll Auto Cut Off
source.
The selected paper source (Roll Auto Cut On
/Roll Auto Cut Off
match the paper source in the printer driver.
The paper lever is in the released position.
The loaded paper is too thick for head
cleaning.
Flashing:
Paper is jammed.
Paper is almost out.
Paper is not cut correctly after the print job
when Roll Auto Cut On
paper source.
Paper is not loaded straight.
Paper is not detected.
Cut sheet is not ejected correctly.
On:
The installed ink cartridge is empty.
The installed ink cartridges cannot be used
with this printer.
The maintenance tank is full.
Flashing:
The installed ink cartridge is nearly empty.
The maintenance tank is nearly full.
Function
If the printer is turned on while you are
pressing and holding the Pause button, the
printer enters the Maintenance Mode.
The Control Panel
is selected as the paper
/Sheet
) does not
is selected as the
4
or
4
4
4
4
4
4
4
4
4
4
4
201