Confi Rming The Ip Units Connected To The System [Ip Unit Search]; Registering Areas And Remote Sites [System Setting - Area/Site Registration] Required - Aiphone IS SERIES Setting Manual

Confi rming the IP units connected to the
system [IP unit search]
Before confi guring system wide settings, confi rm the IP
units are connected to the network, and set the network
setting for each IP unit using [IP unit search].
1 Click IP unit search in the table of contents.
2
IP unit search
Click .
All the IP units connected to the system are displayed in
the list.
If IP units are not displayed, repeat this step until
*
displayed.
3 Confi rm the "Station type", "MAC address" and "Unit
name" of the IP units in the list.
4 To make or change settings to an IP unit,
check the box for the target IP unit and click
Open the setting window
Another window opens. You can make settings for the
target IP unit individually. (→P. 18)
5 Close the window.
Repeat step 3 to 5 to make settings to other IP units.
*
NOTES:
This procedure cannot search for PC master stations (IS-SOFT)
•
and it is not a system failure. To add a PC master station (IS-SOFT)
in the system, install the application (IS-SOFT) to a PC before
connecting it to the network and see page 21.
It may be required to log in to open the setting window, and update
•
the system at [Updating the system] before closing the window.
20
.
Registering areas and remote sites
[System setting – Area/Site registration]
Required
Register areas (for separating stations in your site) and/
or remote sites. The number to which a name is entered is
registered as an area or site number. Up to 99 areas and/or
sites (up to 31 for sites only) can be registered.
1
Click Area/Site registration in the table of contents.
2
Enter an area name in the cell for the area number 01.
Be sure to enter an area name. A site cannot be
*
registered to the number 01.
The fi gures under "Number" in the tables means the area
*
or site numbers.
3
Enter area and/or site names in the cells for other
numbers to register more areas and/or sites.
• Select "Area" or "Site" from the pull-down menu of "Area/
Site".
• For a site, enter the IP address (global IP address of the
target site), port number and connection password for
the target site.
• For a site, set "Door release" to enable (ON) or disable
(OFF) the door release action from the target site.
4
Click
Temporarily stored
results temporarily.
If you wish to cancel the setting results you have made,
*
click a title in the table of contents or "Refresh" in the
web browser menu.
NOTES:
Be sure to register at least one area to the area number 01.
•
("1" is entered in the cell for the area number 01 as default.)
A call number displayed on the master station monitor consists of
•
an area number plus a station number (when called from within
your site).
to save the current setting