•
Keep print media stored in an acceptable environment. See
•
Do not remove trays during a print job.
•
Push all trays in firmly after loading them.
•
Make sure the guides in the trays are properly positioned for the size of print media you have loaded. Make
sure the guides are not placed too tightly against the stack of print media.
•
If a jam occurs, clear the entire media path.
Tools required
Flat-blade screwdrivers, various sizes
Phillips screwdrivers, various sizes
7/32 inch open-end wrench
7.0 mm nut driver
5.5 mm wrench
Needlenose pliers
Diagonal side cutters
Spring hook
Feeler gauges
Analog or digital multimeter
Parallel wrap plug 1319128
Twinax/serial debug cable 1381963
Flash light (optional)
"Storing print media" on page
General information
7002-xxx
1-16.
1-17