Ep Setup; Ep Defaults; Fuser Temperature (Fuser Temp); Fuser Page Count - Lexmark X642e Service Manual

7002-xxx

EP SETUP

Models X644e/X646e
EP SETUP

EP Defaults

Fuser Temp

Fuser Page Count

Warm Up Time

Transfer
Print Contrast
Submit
The triangles pointing up or down indicate whether there are additional menus. Touch the up or down arrows to
display these additional menus.
Note: If you make changes, touch Submit to make the change effective.
EP Defaults
This setting is used to restore each printer setting listed in EP SETUP to its factory default value. Sometimes this
is used to help correct print quality problems.
To restore EP Defaults:
1.
Touch
2.
Touch
Restore to exit without changing the settings.
Touch Back to exit without changing the settings.

Fuser Temperature (Fuser Temp)

This adjustment can be used to help solve some customer problems with paper curl on low grade papers and
problems with letterheads on some types of media.
The fuser temperature can be adjusted to: Normal, Lower, Lowest. The default is Normal.
Touch Back to return to Diagnostics Menu.
Fuser Page Count
The fuser page count can only be viewed and cannot be changed.
Touch Back to return to Diagnostics Menu.
Warm Up Time
You can change the amount of time the printer warms up before allowing pages to print by changing this setting
from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets the backup roll heat up
and helps reduce curl in some environments.
3-20
Service Manual
Normal
127
Medium
Medium
Back
to select EP Defaults from EP SETUP.
to select Restore to reset the values to the factory settings, and touch
Model X642e
EP SETUP
EP Defaults
Fuser Temp
Normal
Fuser Page Count
127
Warm Up Time
0
Submit
Back
to select Do Not