Configuring Port Roles - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 Internet Security Appliance
LABEL
Gateway IP Address
Rapid Spanning Tree Protocol Setup
Enable Rapid Spanning
Tree Protocol
Bridge Priority
Bridge Hello Time
Bridge Max Age
Forward Delay
Bridge Port
RSTP Active
RSTP Priority
0(Highest)~255(Lowest)
RSTP Path Cost
1(Lowest)~65535(Highest)
Apply
Reset
5.4

Configuring Port Roles

Click BRIDGE, then Port Roles to configure a LAN/DMZ port as a LAN or DMZ port.
To configure a LAN/DMZ port as a LAN or DMZ port, select its radio button next to LAN or DMZ
and click Apply. Otherwise, click Reset to restore the previous configuration. The radio buttons
correspond to Ethernet ports on the front panel of the ZyWALL. By default, ports 1 to 4 are all LAN
ports.
5-4
Table 5-3 Bridge
Enter the gateway IP address.
Select the check box to activate RSTP on the ZyWALL.
Enter a number between 0 and 61440 as bridge priority of the ZyWALL. 0 is the
highest.
interval (between 6 and 40) in seconds that the root bridge waits
Enter an
before sending a hello packet.
(between 6 and 40) in seconds
Enter an interval
Hello BPDU from the root bridge.
(between 6 and 40) in seconds
Enter the length of time
in the listening and learning port states. The default is 15 seconds.
This is the bridge port type. Port types are: WAN, LAN, WLAN and DMZ.
Select the check box to enable RSTP on the corresponding port.
Enter a number between 0 and 255 as RSTP priority for the corresponding port. 0
is the highest.
Enter a number between 1 and 65535 as RSTP path cost for the corresponding
port. 65535 is the highest.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
that a bridge waits to get a
that a bridge remains
Bridge Screen