Set Up Instructions - Stamina Conversion II9003 Owner's Manual

SET UP INSTRUCTIONS

Place the Conversion II ® 9003 in the area where it will be used. It is recommended that the
Conversion II ® 9003 be placed on an equipment mat. The Conversion II ® 9003 is approximately 77.8
inches long x 23 inches wide x 30.6 inches tall. (These dimensions may vary up to one inch.) An area
4 feet wide x 8.5 feet long is required for safe operation of the Conversion II ® 9003. Make sure that
adequate space is available for access to and passage around the Conversion II ® 9003.
LEVELING: Adjust the location of Conversion II ® 9003 so the machine sits on the floor without rocking.
MOVING: The Conversion II ® 9003 has a pair of MOVING WHEELS(76) on the FRONT
STABILIZER(2). Grasp the RAIL CAP(55) to move the Conversion II ® 9003.
FUNCTION INSPECTION:
Visually inspect the Conversion II ® 9003 to verify that assembly is as shown in the above illustration.
Check the function of the Conversion II ® 9003 by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(27) and verify that
it functions properly.
CAUTION: Locate and read the CAUTION LABEL(129) on the Conversion II ® 9003. Make sure that
all users read the CAUTION LABEL(129) before using the product.
Equipment Mat
(not included)
11