Hitachi SJ200 Series Instruction Manual page 252

B–38
ModBus Data Listing
Func.
Code
C082 OI input span calibra-
tion
C085 Thermistor input tuning R/W Range is 0.0 to 200.0%
C086 [AM] terminal offset
tuning
C091 Debug mode enable
C101 Up/Down memory
mode
selection
C102 Reset selection
C141 Input A select for logic
output
C142 Input B select for logic
output
C143 Logic function select
C144 Terminal [11] ON delay
C145 Terminal [11] OFF
delay
"C" Group Intelligent Terminal Functions
Name R/W
R/W Scale factor between the
external frequency command
on terminals L – OI (current
input) and the frequency
output, range is 0.0 to 200.0%
R/W Range is 0.0 to 10.0V
— Displays debug parameters.
Two option codes:
00... Disable
01... Enable
R/W Controls speed setpoint for the
inverter after power cycle. Two
option codes:
00... Clear last frequency
(return to default frequency
F001)
01... Keep last frequency
adjusted by UP/DWN
R/W Determines response to Reset
input [RST].
Three option codes:
00... Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
01... Cancel trip state at signal
OFF transition, stops inverter if
in Run Mode
02... Cancel trip state at input
signal ON transition, no effect
if in Run Mode
R/W
R/W
R/W Applies a logic function to
calculate [LOG] output state,
three options:
00... [LOG] = A AND B
01... [LOG] = A OR B
02... [LOG] = A XOR B
R/W Range is 0.0 to 100.0 sec.
R/W Range is 0.0 to 100.0 sec.
Description
"Output Logic and
See
Timing" on page 3–53
Network Data
Reg. Range Res.
00C8h 0 to 2000 0.1 %
00EEh 0 to 2000 0.1 %
00C9h 0 to 100 0.1 V
— — —
00CFh 0, 1 —
00D0h 0, 1, 2 —
00EFh 0, 1, 2, 3, —
4, 5, 6, 7,
8, 9
00F0h
00F1h 0, 1, 2 —
00F2h 0 to 1000 0.1 sec
00F3h 0 to 1000 0.1 sec