Fitting The Universal Front Filler - HP Vectra VL series 8 Maintenance Manual

NOTE
13 Connect the power cable to the rear of each drive.
The connectors are shaped to fit one way only.
14 Replace the power supply. Then push the front drive unit fully into
the computer until the two retaining clips click into place.
15 If the drive you are installing requires it, fit the universal front filler.
Refer to the next section, "Fitting the Universal Front Filler" on page
21 for instructions.
16 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
17 Verify the new configuration by checking the HP Summary Screen.
To access the HP Summary Screen, press
appears during startup.

Fitting the Universal Front Filler

You only need to use the universal front filler if there is a gap around the
newly installed device.
1 Retrieve the universal front filler from the PC's chassis by pulling it
free of the retaining clips. (You can also order the universal front
filler for your PC from any authorized HP reseller.).
1 How to Install Accessories In Your PC
Universal front filler
Installing Mass Storage Devices
when the Vectra logo
English 21