HP Vectra VL series 8 Maintenance Manual page 27

NOTE
9 Replace the metal plate at the rear of the computer. Insert the flat
end first then push it until it clicks into place.
10 Connect the power cable and the data cable to the rear of the drive.
The connectors are shaped to go in one way only. If you are not
sure which connector to use, refer to "Connecting Devices", on page
9.
11 Install any other accessories before replacing the power supply and
cover. Reconnect all cables and power cords.
12 Verify the new configuration by checking the HP Summary Screen.
To access the HP Summary Screen, press
appears during startup.
If you intend to boot from the newly installed drive, ensure that you
have configured Setup to do this. Also ensure that you have installed all
the required operating system and HP drivers on the newly installed
drive. To reinstall operating system and HP drivers, use the Software
Recovery CD-ROM provided with the PC. In addition, you can find the
most up-to-date versions of HP drivers on HP's Web site at:
http://www.hp.com./go/vectrasupport/
1 How to Install Accessories In Your PC
Installing Mass Storage Devices
when the Vectra logo
.
English 17