Installing An Ide Hard Disk Drive In The Bottom Rear Shelf - HP Vectra VL series 8 Maintenance Manual

CAUTION

Installing an IDE Hard Disk Drive in the Bottom Rear Shelf

Handle the hard disk drive with care. Avoid shocks and violent
movement as this can cause damage to the hard disk drive's internal
components.
Make sure that you back up your files before you install a hard disk
drive. Refer to your operating system documentation for information on
how to do this.
The PC has an integrated Enhanced IDE controller which supports two
Ultra ATA IDE hard disk drives. Refer to the drive's documentation to
see if you must set jumpers or if there is a special installation
procedure to follow.
You can install either a 3.5-inch or a 5.25-inch hard disk drive in this
shelf. It is recommended that you use this shelf if you want to replace
the existing hard disk drive. You can use the top rear shelf (located
under the power supply) if you want to install a second hard disk drive.
1 Disconnect the computer's power supply cord and any connection to
a telecommunication network.
2 Remove the computer's cover and power supply.
3 At the rear of the computer, unlatch the metal plate and remove it.
4 If there is a disk drive on the bottom tray (and you want to replace
it), disconnect the power cable and data cable from this drive.
1 How to Install Accessories In Your PC
Installing Mass Storage Devices
English 15