HP Vectra VL series 8 Maintenance Manual page 24

NOTE
1 How to Install Accessories In Your PC
Installing Mass Storage Devices
6 Carefully lower the tray back into position by aligning the metal tabs,
then slide it backwards into place.
7 At the rear of the PC, replace the retaining bracket and screw it in
place, securing the tray.
8 Connect the power cable and the data cable to the rear of the drive.
The connectors are shaped to go in one way only. If you are not
sure which connector to use, refer to "Connecting Devices", on page
9.
Data cable
9 Install any other accessories before replacing the power supply and
cover. Reconnect all cables and power cords.
10 Verify the new configuration by checking the HP Summary Screen
To access the HP Summary Screen, press
appears during startup.
If you intend to boot from the newly installed drive, ensure that you
have configured Setup to do this. Also ensure that you have installed all
the required operating system and HP drivers on the newly installed
drive. To reinstall operating system and HP drivers, use the Software
Recovery CD-ROM provided with the PC. In addition, you can find the
most up-to-date versions of HP drivers on HP's Web site at:
http://www.hp.com./go/vectrasupport/
14 English
Power cable
when the Vectra logo
.