Cd-Rom Drive Door Does Not Open; If An Accessory Board Does Not Work - HP Vectra VL series 8 Maintenance Manual

Using the manual eject feature.
The picture shows two possible
locations of the manual eject button.

CD-ROM Drive Door Does Not Open

If you have difficulty removing a CD-ROM disk from the CD-ROM drive
(during a power failure for example), you can use the manual eject
button.
To eject a CD-ROM disk using the manual eject button:
1 With a thin, solid rod, such as the end of a paper clip, push the
CD-ROM's manual eject button.
2 The CD-ROM drive door will be released, opening slightly. Carefully
pull it open fully and retrieve the disk.
3 To close the CD-ROM drive door, push it gently closed without
forcing it. The CD-ROM drive door may not close completely until it
is fully functional (for example, when the power comes back on).

If an Accessory Board Does Not Work

1 Ensure the board has been firmly installed in the slot.
2 Check that the accessory board has been correctly configured.
3 Ensure the board is not using memory, I/O addresses, an IRQ, or
DMA also used by the PC. Refer to the board's manual for further
details.
3 Troubleshooting Your PC
If Your PC Has a Hardware Problem
English 57