Installing An Ide Hard Disk Drive In The Bottom Shelf - HP Vectra VL5 3 User Manual

Installing an IDE Hard Disk Drive in the Bottom Shelf

# $ K +
The PC has an integrated Enhanced IDE controller which supports two Fast IDE hard disk
drives.
Refer to the drive's manuals to see if you must set jumpers or if there is a special installation
procedure to follow.
1. Disconnect the computer's power supply cord.
2. Remove the computer's cover.
3. Unscrew the hard disk drive in the rear shelf and rotate it out of the way for better access to
the cables.
4. If there is a device in the middle shelf, remove it.
5. If there is no device in the middle shelf, remove the RFI plate.
6. Remove the screw from the front panel.
7. Pass the drive through the middle shelf and lay it on the bottom shelf.
8. Push the drive towards the front panel, so it passes over the two slots in the base of the shelf
and engages into the bracket on the front panel.
9. Secure the drive by replacing the screw on the front panel.
10. Connect the power and data cables to the rear of the drive.
The connectors are shaped to fit one way only.
11. If a device was removed from the middle shelf, replace it.
12. If no device was removed from the middle shelf, replace the RFI plate.
13. Replace the hard disk drive in the rear shelf.
14. Install any other accessories before replacing the cover.
15. Refer to "Completing the Installation of an IDE Drive" to complete the installation.
#
InstallinganIDEHardDiskDriveintheBottomShelf.35
$
Installing an IDE Hard Disk Drive in the Bottom Shelf
K
Installing an IDE Hard Disk Drive in the Bottom Shelf;IDE drives;installing
+
SECTION3:0080
HP Vectra VL5 PC User's Guide - Part 2Error! No text of specified style in document.
38
{bmc help0039.bmp}
{bmc help0040.bmp}
{bmc help0041.bmp}