Installing A Serial Port Adapter - Dell OptiPlex GX60 System User's Manual

4. If necessary, disconnect any cables connected to the card.
5. Grasp the card by its top corners, and ease it out of its connector.
6. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep dust
and dirt out of your computer.
7. Lower the retention arm and press it into place.
Serial Port Adapters
CAUTION: Before you begin any of the procedures in this section, follow the
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

Installing a Serial Port Adapter

1. Follow the procedures in "Before You
2. Remove the card cage (see
3. Press the lever on the retention arm and raise the retention arm.
4. Remove the filler bracket.
5. Slide the adapter bracket down over the card slot opening, and lower the retention arm, securing the adapter bracket.
1 retention arm
2 filler bracket
3 card bracket
6. Route the serial card cable under the card cage, and attach the cable to the connector on the system board (labeled SER2).
Dell.
Begin."
step 1 in the first procedure).
safety instructions.