Dell OptiPlex GX60 System User's Manual page 131

Serial Port Adapters
Installing a Serial Port Adapter
CAUTION: Before you perform this procedure, follow the
1. Follow the procedures in "Before You
2. Raise the retention arm.
3. Remove the filler bracket.
4. Slide the adapter bracket down over the card slot opening, and lower the retention arm, ensuring that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide (see
l
5. Attach the serial card cable to the connector on the system board (labeled SER2).
1 SER2 system board
connector
2 card bracket
3 serial card cable
4 card slot opening
6. Lower the retention arm into place, securing the card(s) in the computer.
7. Proceed with step 7 in the next procedure.
Removing a Serial Port Adapter
CAUTION: Before you perform this procedure, follow the
1. Follow the procedures in "Before You
2. Disconnect the serial adapter cable from the connector on the system board.
3. Raise the retention arm.
4. Lift and remove the card bracket.
safety instructions.
Begin."
safety instructions.
Begin."
step 8 of the previous procedure).