Dell OptiPlex GX60 System User's Manual page 122

Front-Panel Inserts
If you are installing a new floppy or CD/DVD drive rather than replacing a drive, remove the front-panel insert.
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1. Follow the procedures in "Before You
2. If you are installing a new floppy drive rather than replacing a drive,
Removing a Floppy Drive
1. Disconnect the floppy-drive cable from the system board connector (DSKT).
2. Remove the power cable from the interposer board.
3. Disconnect the CD/DVD drive cable
4. Remove or raise the drive by pressing the green tabs on either side of the drive and lifting the drive up.
5. Remove the floppy-drive cable from the floppy drive:
a. Remove the interposer board from the floppy drive by pressing the tab and rotating the interposer board.
1 floppy-drive cable
Begin."
remove the front-panel
and the power cable from the CD/DVD drive.
safety instructions.
inserts.