Dell OptiPlex GX60 System User's Manual page 123

2 tab
3 interposer board
4 system board floppy-drive connector (DSKT)
b. To release the floppy-drive cable from the connector, slide the lever until it is fully extended, and then lift the cable away.
1 floppy-drive cable
2 lever
6. Remove the floppy drive from its sled by pulling the sled tab out while pushing the drive up and then sliding the drive out of the sled.
1 sled tab
2 sled
Installing a Floppy Drive
1. Snap the replacement drive into the sled and ensure that it is secure in the sled.
2. Connect the interposer board to the floppy drive:
a. Slide the floppy-drive cable into the connector.
b. Close the lever so that the cable is secure in the connector.
c. Line up the hole on the bottom of the interposer board with the notch on the connector, and snap the interposer board onto the drive.
3. Gently slide the drive into the computer until the tabs securely click into position.