D-Link NetDefend DFL-210 Cli Reference Manual page 147

3.32.1. IPRule
SATTranslateToPort
SATAllToOne
SLBAddresses
SLBStickiness
SLBIdleTimeOut
SLBMaxSlots
SLBNetSize
SLBNewPort
SLBMonitorRoutingTable
SLBMonitorPing
SLBPingPollingInterval
SLBPingSamples
SLBPingMaxPollFails
SLBPingMaxAverageLatency
SLBMonitorTCP
SLBTCPPorts
SLBTCPPollingInterval
SLBTCPSamples
SLBTCPMaxPollFails
SLBTCPMaxAverageLatency
SLBMonitorHTTP
SLBHTTPPorts
SLBHTTPPollingInterval
SLBHTTPSamples
SLBHTTPMaxPollFails
Translate to this port. (Optional)
Rewrite all destination IPs to a single IP. (Default: No)
The IP addresses of the servers in the server farm.
Specifies stickiness mode. (Default: None)
New connections that arrive within the idle timeout are as-
signed to the same real server as previous connections from
that address. The timeout is refreshed after each new connec-
tion. (Default: 30)
Specifies maximum number of slots for IP and network stick-
iness. (Default: 2048)
Specifies network size for network stickiness. (Default: 24)
Rewrite destination port to this port. (Optional)
Routing table used for server monitoring. (Default: main)
Enable monitoring using ICMP Ping packets. (Default: No)
Delay in milliseconds between each ping interval. (Default:
5000)
Specifies the number of attempts to use for statistical calcula-
tions. (Default: 10)
Specifies the maximum number of failed ping attempts until
host is considered to be unreachable. (Default: 2)
Specifies the max average latency for the sample attempts.
(Default: 800)
Enable monitoring using TCP handshakes. (Default: No)
Specifies the ports that will be monitored.
Delay in milliseconds between each TCP handshake.
(Default: 10000)
Specifies the number of attempts to use for statistical calcula-
tions. (Default: 10)
Specifies the maximum number of failed TCP attempts until
host is considered to be unreachable. (Default: 2)
Specifies the max average latency for the sample attempts.
(Default: 800)
Enable monitoring using HTTP requests. (Default: No)
Specifies the ports that will be monitored. (Default: 80)
Delay in milliseconds between each monitor interval.
(Default: 10000)
Specifies the number of attempts to use for statistical calcula-
tions. (Default: 10)
Specifies the maximum number of failed HTTP attempts until
host is considered to be unreachable. (Default: 2)
147
Chapter 3. Configuration Reference