Table of Contents
Advertisement
Once the relay is activated by your fax and as soon as the document is received by the remote fax, the
document is printed before relaying to all subcribers on the list.
To activate relay from your fax machine:
Insert the document to relay (refer to paragraph Document positioning, page 5-1).
Select M 37 OK - FAX / BROADCAST.
Enter the remote fax number where you will relay to or choose your dialling mode (refer to
paragraph Dialling, page 5-2) and press OK.
Enter the relay list number used by the remote fax and press OK.
You may enter the time you wish to transmit the document next to the current time and press OK.
If you wish to modify the document feed type, select one of the options
then press OK.
If you wish, you may enter the number of pages of your documents before transmitting.
Activate relay by pressing key
The document in the feeder will be relayed either immediately or at a later time (according to your
choice) to the remote fax which will relay the document.
As delivered your fax is preset by default. However, you may adjust it to meet your requirements by
resetting the technical parameters.
To set the technical parameters:
Select the desired parameter and confirm with OK.
With the keys
press OK.
Parameter
1 - SCANNING
MODE
2 - TX HEADER
T
ECHNICAL PARAMETERS
or
, modify the parameter settings by following the table below and
Setting
Default value of the scan mode resolution for the documents
1 - NORMAL
to be transmitted.
2 - FINE
3 - SFINE
4 - PHOTO
If this parameter is on, your header will appear on all
1 - WITH
documents sent to your subscribers with your name, number,
2 - WITHOUT
date and number of pages.
Warning: If you send a fax from the document loader, the
transmission header will not appear on the document your
correspondent receives.
3-6
.
M 29 OK - SETUP / TECHNICALS
Signification
Setting your machine
or
,
FEEDER
MEMORY
Advertisement
Table of Contents
