Table of Contents
Advertisement
Error messages
If the printer has one of the problems described below, the signal "On" flashes red, and you can't use
your machine temporarily. The corresponding message is displayed on the screen.
Message
CHANGE TONER
<OK> TO CONFIRM
CHANGE DRUM
<OK> TO CONFIRM
CANNOT READ
CHECK DIRECTION
CLOSE COVER
DRUM NEAR END
TONER NEAR END
PAPER EMPTY
PAPER JAM INSIDE
PAPER JAM
EXTERNAL TRAY
PAPER JAM
INTERNAL TRAY
PRINTER ERROR XX
PAPER SIZE ERROR
P
RINTER ERRORS
Replace the toner cartridge.
Proceed as indicated Replacing the toner cartridge, page 6-2.
Replace the drum cartridge.
Proceed as indicated Replacing the drum cartridge, page 6-7.
Remove the chip card and insert it the other way around (green
arrow).
Close the front cover of the printer
The drum is nearly worn out (10% use left)
The toner cartridge is nearly worn out (10% capacity left)
Install the paper tray.
Fill the tray with paper in the required size.
Open the tray.
Remove the jammed sheet.
Open the cover.
Remove the jammed sheet from the print outlet.
Open the cover.
Remove the jammed sheet from between the tray and the fusing unit.
Disconnect and reconnect the terminal.
If the problem persists, contact your supplier.
Check paper size (A4 / LETTER / ...)
6-18
Maintenance
Action
Advertisement
Table of Contents
