Foxconn 400M01 Series Manual page 6

1 Flash Rom
This 4Mb firmware contains the programmable BIOS program.
2 ATX power connector
This 20-pin connector connects to an ATX power supply. The power supply
must have at least 1A on the +5V standby lead (+5VSB).
3
AGP slot
This Accelerated Graphics Port (AGP) slot supports 1.5V AGP 8X/4X mode
graphics cards for 3D graphical applications.
4
CPU socket
Socket 462 (socket A) Zero Insertion Force (ZIF) for the AMD processor,
with 200/266/333/400MHz (400MHz only for KM400A) system bus.
5
North Bridge controller
The VIA KM400/KM400A controller integrates a high performance host
interface for the AMD processor, a DDR memory controller, and support AGP
8X/4X technology. It also loaded with the VIA UniChrome
core for efficient multimedia applications including DVD and video playback
support.
6
DDR DIMM sockets
These two 184-pin DIMM sockets support up to 2GB system memory
using unbuffered non-ECC PC1600/PC2100/PC2700/PC3200 (only for
KM400A) DDR DIMMs.
7 IDE connectors
These dual-channel bus master IDE connectors support Ultra DMA 133/
100/66/33 devices. Both the primary (blue) and secondary (white) connectors
are slotted to prevent incorrect insertion of the IDE ribbon cable.
8
Serial ATA connectors (only for VT8237)
These connectors support Serial ATA HDDs and allow for up to 150MB/s
data transfer rate, faster than the standard Parallel ATA with 133MB/s.
6
400M01-FOXCONN-V1.0-HW-en-030304.p65
Chapter 1
400M01 Series User Manual
6
Product Introduction
2D/3D graphics
TM
2004-3-18, 13:51