Foxconn 400M01 Series Manual page 44

Boot Other Device (Default: Enabled)
With this function set to enable, the system will boot from some other de-
vices if the first/second/third boot devices failed. The setting values are: Dis-
abled and Enabled.
Swap Floppy Drive (Default: Disabled)
If you have two floppy diskette drives in your system, this option allows you to
swap the assigned drive letters. The setting values are: Disabled and Enabled.
Boot Up Floppy Seek (Default: Enabled)
If this option is enabled, BIOS will tests floppy drives to determine whether
they have 40 or 80 tracks.The setting values are: Disabled and Enabled.
Boot Up NumLock Status (Default: On)
This option defines if the keyboard Num Lock key is active when your system
is started. The setting values are: On and Off.
Typematic Rate Setting (Default: Disabled)
If this option is enabled, you can use the following two items to see the
typematic rate and the typematic delay settings for your keyboard. The avail-
able setting values are: Disabled and Enabled.
Typematic Rate (Chars/Sec) (Default: 6)
Use this option to define how many characters per second a held-down
key generated.
Typematic Delay (Msec) (Default: 250)
Use this option to define how many milliseconds must elapse before a held-
down key beings generating repeat characters.
Security Option (Default: Setup)
When it is set to "Setup", a password is required to enter the CMOS Setup
screen; When it is set to "System", a password is required not only to enter
CMOS Setup, but also to start up your PC.
APIC Mode (Default: Enabled)
This option is used to enable or disable APIC mode. The available setting
values are: Disabled and Enabled.
44
400M01-FOXCONN-V1.0-BIOS-en-030304.p65
Chapter 3
400M01 Series User Manual
44
BIOS Description
2004-3-18, 13:49