Faults; Correcting Faults; Resetting The Control Electronics - Henny Penny SMART COMBI FM05-061-A Operating Manual

Faults

Requirements
12. 08. 2008 13:32
Demo mode
Menu RackCont.
ΔT/LTC/...
12. 08. 2008 13:32
Menu RackCont.
ΔT/LTC/...
74
6 Faults

6.1 Correcting faults

This section describes the steps to be taken in the event that faults with
the unit occur during operation.
1. Reset control electronics
Page 74).
2. Observe the information in the table "Causes of faults and
troubleshooting"
Page 75).
3. Contact customer service.

6.2 Resetting the control electronics

Unit is switched on
Errors in the program sequence (e.g. deviations from the set values) can
be corrected by resetting (initialising) the control electronics.
This resets the electronics to the start mode.
NOTICE
Stored programs are not deleted when doing this!
1. Hold On / O f f ( 1 ) pressed for about 8 seconds, until the control
electronics switch off.
The multi-function display (4) goes dark.
2. After about 10 seconds, the control electronics switch on again
automatically.
3. If the unit is switched off and O n / O f f ( 1 ) is pressed for longer than
20 seconds, the control electronics change to Demo mode.
The multi-function display (4) shows "Demo mode".
4. To leave demo mode, switch off the unit and press O n / O f f ( 1 ) until
the unit switches on again.
The control electronics switch back to the normal operating mode.
Unit is in start mode (standby).
Operating manual
SmartCombi
(Chapter "Resetting the control electronics",
(Chapter "Cause of errors and troubleshooting",
™
Global Foodservice Solutions