Waveclean Faults - Henny Penny SMART COMBI FM05-061-A Operating Manual

SmartCombi
5.1.7 "WaveClean" faults
Information regarding
operation with hard water
Global Foodservice Solutions
™
→ Press the left s e le c t bu t t o n ( 1 3 ) to abort the cleaning program.
NOTICE
For safety reasons, a rinsing process (duration 12 minutes) runs
automatically when WaveClean is cancelled.
Discolouring may occur to the floor of the cooking chamber underneath
the cartridge. This discolouring is harmless and does not have any
effect on the operation of the unit.
Fault
Cartridges are not
●
fully emptied
Residues of clean-
●
er/rinsing agent re-
main in the cartridge
Rinsing agent is re-
●
leased at the same
time as the cleaner
Cooking chamber re-
●
mains dry
Cooking chamber is
●
not clean
Table 8: Causes of faults and troubleshooting
NOTICE
The unit can be used without softening the water up to a hardness
of 5 °dH. However, water having a total hardness exceeding 0 °dH
contains lime scale, which may form deposits in the cooking chamber.
The amount of lime scale deposited in the cooking chamber is
normally so low that it has no detrimental effect on the operation of
the unit. However, there may be white deposits in the cooking
chamber.
The two-in-one cartridges contain a clear rinsing agent with descaling
properties, which usually prevents these deposits from building up if
the "WaveClean" automatic cleaning function is used regularly.
Operating manual
Possible cause
Unit is leaning
Power failure/unit mal-
function
Holder is bent: cartridge
too close to the floor
Heater not working
Circulating pump defect-
ive
Cooking chamber too
heavily soiled
Washing water circula-
tion interrupted
Cleaning
Remedy
Adjust the unit horizont-
ally
Contact customer service
Adjust holder position
Contact customer service
Contact customer service
Empty outlet filter be-
●
fore cleaning.
Remove heavy soiling
●
and large particles
manually before
cleaning.
Shorten the cleaning
●
interval.
65