Dell C7765dn User Manual page 657

Status Code
027-772
[Cause]
[Remedy] Use ASCII characters to modify the host name that has been specified under [Tools] >
027-773
[Cause]
[Remedy] Wait for a while, and then execute the operation again.
027-774
[Cause]
[Remedy] Specify the e-mail address using only ASCII characters.
027-775
[Cause]
[Remedy] Reduce the number of destination addresses. If the error still is not resolved, confirm
027-776
[Cause]
[Remedy] Use ASCII characters to modify the host name that has been specified under [Tools] >
027-777
[Cause]
[Remedy] Set [E-mail Send Authentication] to [Off] under [Tools] > [System Settings] >
027-778
[Cause]
[Remedy] Confirm the authentication type supported by the SMTP server with your network
027-779
[Cause]
[Remedy] Confirm the login name and password set to SMTP-AUTH.
027-796
[Cause]
[Remedy] To print the mail body or header information also, change settings in the [Properties]
027-797
[Cause]
[Remedy] Specify a correct output destination, and send the e-mail again.
An error occurred during communication with the SMTP server.
[System Settings] > [Connectivity & Network Setup] > [Machine's E-mail Address /
Host Name]. If the error still is not resolved, confirm with your network administrator
whether the SMTP server supports the HELO command.
An error occurred during communication with the SMTP server.
The specified e-mail address contains unsupported characters.
Too many destination addresses have been specified.
with your network administrator whether the SMTP server supports the EHLO
command.
An error occurred during communication with the SMTP server.
[System Settings] > [Connectivity & Network Setup] > [Machine's E-mail Address /
Host Name]. If the error still is not resolved, confirm with your network administrator
whether the SMTP server supports the EHLO command.
The destination SMTP server does not support SMTP-AUTH.
[Connectivity & Network Setup] > [Outgoing / Incoming E-mail Settings] > [SMTP
Server Settings].
The destination SMTP server does not support the SMTP-AUTH system set on the
machine.
administrator. The machine supports the following authentication types: AUTH
GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH
LOGIN, AUTH CRAM-MD5.
Failed to authenticate the SMTP server.
The received e-mail was discarded because no documents were attached to it. (The
machine is set to print attached documents only.)
screen of Dell Printer Configuration Web Tool.
The output destination of the received e-mail is invalid.
Cause and Remedy
Status Code
657