Dell C7765dn User Manual page 649

Status Code
027-444
[Cause]
[Remedy] Change the [Auto Stateless Address 3] for IPv6 on the machine, or the IP address of IPv6
027-445
[Cause]
[Remedy] Set the IP address correctly.
027-446
[Cause]
[Remedy] Change the [Manually Configured IPv6 Address] on the machine, or the IP address of
027-447
[Cause]
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the IP address of IPv6 on
027-452
[Cause]
[Remedy] Change the IP address of IPv4 set on the machine or the IP address of IPv4 on the
027-500
[Cause]
[Remedy] Specify the SMTP server name correctly or specify the server by using its IP address.
027-501
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact Customer Support
027-502
[Cause]
[Remedy] Confirm whether the user name and password used in the POP3 server are correct on
027-503
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact Customer Support
027-504
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact Customer Support
027-513
[Cause]
[Remedy] Consult your system administrator for settings.
027-514
[Cause]
[Remedy] Check the following conditions:
027-515
[Cause]
[Remedy] Take the following measures:
The IP address of IPv6 already exists.
on the network device, to remove the duplication of addresses.
IP address for IPv6 set manually is incorrect.
The IP address of IPv6 set manually already exists.
IPv6 on the network device, to remove the duplication of addresses.
The IP address of IPv6 already exists.
the network device, to remove the duplication of addresses.
IP address of IPv4 already exists.
network device.
Unable to connect to the SMTP server.
A POP server error occurred.
at dell.com/contactdell.
Failed to log into the POP3 server when using the POP3 protocol.
Dell Printer Configuration Web Tool.
A POP server error occurred.
at dell.com/contactdell.
An SMTP server error occurred.
at dell.com/contactdell.
The machine failed to transfer data using SMB of the Scan to PC service because access
to the SMB server was not permitted.
When the server is Macintosh, a folder with the same name as the specified file name
may exist on the server.
The machine failed to transfer data using SMB of the Scan to PC service because an error
has been occurred between the SMB server and the DNS server.
• The SMB server is connected to the DNS server.
• The SMB server name is registered on the DNS server.
The machine failed to transfer data using SMB of the Scan to PC service because an error
has been occurred.
• Set the DNS server address.
• Set the target SMB server address using IP address.
Cause and Remedy
Status Code
649