SOYO SY-TISU User Manual page 48

Hardware Installation
Please clear the CMOS via JP5 then choose 'load optimized default' in the
bios and save the bios and exit. Next, unplug all other add-on cards except
the video card and floppy drive controller, and see if it can boot from
floppy. Then put back the peripherals one by one to identify which one
causes the lockup.
I can not get my board to run properly.
Please make sure you have the latest bios and driver from the SOYO web
site at: http://www.soyo.com
Note on Over-clocking Capability
The SY-TISU provides over-clocking capability. Due to the
over-clocking setting your system may fail to boot up or hang during run
time. Please perform the following steps to recover your system from the
abnormal situation :
1. Turn off system power (If you use an ATX power supply, and
depending on your system, you may have to press the power button
for more than 4 seconds to shut down the system.)
2. Press and hold down the <Insert> key while turning on the system
power. Keep holding down the <Insert> key until you see the
message of the CPU type and frequency shown on the screen.
3. Press the <Del> key during the system diagnostic checks to enter the
Award BIOS Setup program.
4. Select [Save & Exit SETUP] and press <Enter> to save the new
configuration to the CMOS memory, and continue the boot
sequence.
Note: SOYO does not guarantee system stability if the user over clocks
the system. Any malfunctions due to over-clocking are not covered by
the warranty.
44
SY-TISU