Atx Power - SOYO SY-TISU User Manual

Hardware Installation
2-3.3.7 ATX Power Supply
Plug the connector from the power directly into the 20-pin male ATX PW
connector on the Motherboard, as shown in the following figure.
Warning: Follow these precautions to preserve your Motherboard
from any remnant currents when connecting to ATX power supply:
Turn off the power supply and unplug the power cord of the
ATX power supply before connecting to ATX PW connector.
The Motherboard requires a power supply with at least 200 Watts and a
"power good" signal. Make sure the ATX power supply can take at least 720
mA * load on the 5V Standby lead (5VSB) to meet the standard ATX
specification.
* Note: If you use the Wake-On-LAN (WOL) function, make sure the ATX
power supply can support at least 720 mA on the 5V Standby lead (5VSB).
Please install the ATX power according to the following pin assignment:

ATX Power

36
SY-TISU