Table of Contents
Advertisement
11. The following message is displayed:
If you want to map your COM ports now, click Yes and proceed to step 12.
If you want to wait to map your COM Ports until you start WINMCSI, click No and proceed to step
13.
12. The COM Port to MCSI Mapping window is displayed.
If you want to get the first available line, click Map | Close and go to the next section.
If you want a specific line, click a COM port in the Local Port list box, then click the line to which
you want to map that particular COM Port. The status message "Mapped to MCSI" should
appear above the Local Port list box.
Click the Unmap button if you want to unmap a line.
Click the Search button to search for lines on a server.
Click the Close button when finished.
13. The following message is displayed: "WINMCSI Successfully Installed". Click OK.
14. A message is displayed telling you where your old SYSTEM.INI and WIN.INI files have been
backed-up. The message also tells you to restart Windows. Click Restart Windows to complete
the installation.
At this time Your WINMCSI software installation is complete. Proceed to the next section,
"Running the WINMCSI Workstation Software."
MTPSR1-202ST
Chapter 6 - RAS Dial-Out Redirector
71
Advertisement
Table of Contents
